Home maintenance: the cause of the deformation of the overall wardrobe and maintenance matters
[ Chinese wardrobe net ] Wardrobe is an important part of home living furniture, but the overall wardrobe is easily deformed during use. In addition to the material and design reasons, the adverse effects of the processing process, then whether the wardrobe will be deformed during the processing! And how should we prevent the overall wardrobe from deforming.
First, the stacking of parts causes the deformation of the overall wardrobe.
In the production, some operators are convenient for the drawing, the plates are stacked at random, or the plates of the stacked plates are not flat, and even the plates are inclined against the wall, so that the plates are before entering the next process. It has been deformed by its own weight.
Second, the finishing process caused the deformation of the overall wardrobe.
During the finishing process, due to improper use of the process and raw materials, the plate is deformed and deformed as the internal stress of the coating changes.
Third, the effect of finishing putty affects the overall wardrobe.
In the process of painting the door parts, many manufacturers use pig's blood putty or glue to prepare the putty in order to reduce the cost. Because these two kinds of putty contain a lot of water, the substrate commonly used for plate furniture - medium density fiberboard and particleboard The hygroscopicity is particularly strong, so when one side of the door panel member is not put with putty and the other side is coated with such a water-rich putty, the door panel member is hygroscopic and deformed.
Overall wardrobe production process
1. When pressing the tri-ammonia board, it should be piled up with iron trays, after 5-7 days of maintenance, and then subjected to quality inspection, stacked on wooden pallets and sent to the workshop for processing.
2. During the process, pay attention to stacking and smoothing on the assembly line.
3, the glass door and decorative panel door should be hard material edging, which not only can play a certain degree of decoration and embellishment, but also can well correct the deformation of the door components.
The whole wardrobe is in daily use
1. The water content of the wood should be controlled at about 15%. In the south, the air humidity in the area is relatively high, and should be controlled at about 12%. In the north and relatively dry areas, it should generally be no less than 8%. To avoid the impact.
2. The purpose of the paint brush is to protect the wood from the erosion of the external environment. Therefore, the upper and lower crowns of the inside and outside of the wardrobe door and the door have paint, such as a sticker surface, which should also be adhered to.
3, the material used to make the door panel should use blockboard, sandwich panels, such as wood, should avoid the use of easily deformed wood (such as ash) and parts (such as log edges).
Outdoor Grills,Best Outdoor Grill,Portable Outdoor Grills,Gas & Charcoal Outdoor Grills
Jiangmen Merit Metal Electric Appliance Co.,Ltd. , https://www.meritbbq.com