What are the precautions for the use of carbon dioxide incubators?
1. The carbon dioxide incubator cannot be turned on before the water is injected, otherwise the heating element will be damaged.
2. When the cylinder pressure is lower than 0.2MPa, the cylinder should be replaced.
3. The carbon dioxide incubator can be used in a high-precision incubator, in which case the CO2 control system must be turned off.
4. Since the CO2 sensor is calibrated at saturated humidity, the humidifying tray must always be filled with sterilized water.
5. After the incubator has been in operation for several months, the water in the tank may be reduced due to volatilization. When the low water level indicator (WLow12) is on, it should be supplemented with water. First open the overflow pipe, use the funnel to connect the rubber tube to add water from the water injection hole to extinguish the low water level indicator, and then add supplementary water (CP-ST200A plus water 1800ml, CP-ST100A plus water 1200ml), and then block the overflow hole.
6. When the display temperature exceeds the set temperature by 1 °C, the over temperature alarm indicator (OverTemp7) lights up and a sharp alarm sounds. At this time, the power should be turned off for 30 minutes; if the power (temperature control) switch (Power20) is turned on again If it is over temperature, turn off the power and report it to the maintenance personnel.
7. When cleaning the CO2 incubator studio, do not hit the sensor and the stirring motor wind wheel and other components.
8. Minimize the time to open the glass door.
9. If the carbon dioxide incubator is not used for a long time, the moisture in the working room must be removed before closing. Open the glass door and ventilate for 24 hours before closing.
10. Disassemble the indoor bracket cover, use a special special wrench, and do not use excessive force.
11. Before carrying the carbon dioxide incubator, take out the shelf and humidifying tray in the working chamber to prevent the glass door from colliding.
12. The water in the tank must be removed before handling the incubator. When draining, put the rubber tube tightly on the water outlet hole so that the nozzle is lower than the instrument, gently suck a mouth, put down the water pipe, and the water will flow out.
13. Do not invert the handle when carrying the incubator, and do not lift the door to avoid deformation of the door.
Shanghai Qiaoyue Electronics Co., Ltd. specializes in producing blast drying ovens, vacuum drying ovens, biochemical incubators, carbon dioxide incubators, snowflake ice machines, electrothermal constant temperature incubators, test chambers, constant temperature shakers, water tanks, water baths and other laboratory equipment. .
Company website: http://
Product details
With Pet All Star Waste Bags, picking up after your furry friend just got a lot easier. Each package contains a total of 120 bright blue-colored bags in eight separate rolls. Each roll is conveniently sized to fit inside standard poop bag dispensers, ensuring that you have plenty on hand, no matter where your walk takes you and your pooch. The bags are large enough to accommodate waste from dogs of all sizes, and their durability will give you confidence that your pup's poop is safely contained while you prowl for a place to properly dispose of it. Keep the messes at bay with Pet All Star Waste Bags!
Pet waste bags
8 rolls per package
Fits most dispensers
120ct
Flat Bags,Hdpe Doggie Poop Bag,Hdpe Pick Up Poop Bag,Hdpe Clean Up Pet Bags
Taizhou Jinchi Sanitary Product Co., Ltd , https://www.tzjcpetwastebag.com