Heat Transfer Film Hose Printing New Process

Patent Name Heat Transfer Film Hose Printing New Process Patent Applicant Wang Dayu Principal Applicant Address 065800 Wennan County, Hebei Province, South Huangzhuang Industrial Zone Inventor Wang Dayao Application (Patent) No. 200510069550.X Date of Application 2005.05.16 Certification Date Auditing Announcement No. 1693090 Approved Notice Day 2005.11.09 Manual CD-ROM D0545 Main Classification No. B41M5/26 Classification No. B41M5/26; B41F17/10 Subparts Original Application No. Priority Citation A new process for printing heat transfer film hoses, The process steps include: adding a hot printing film, so that the rubber wheel in the device is heated by baking of the thermal tile in the device, and the switch is activated. The pressing cylinder in the device presses the heated rubber wheel to the transfer film to rotate. On the object, until the transfer is completed, the film motor starts to roll the film; after the thermal transfer operation is completed, the cylinder is pressed down to the original position; after the roll film sensor senses the length of the transfer film, the film is stopped; and the transfer film is removed. After the hose; good to be transferred to the hose. Compared with the prior art of hose printing, the present invention has no printing color difference, has good embossing effect, and has various colors and is very vivid. The dots gradually became better and the three-dimensional effect was stronger. The pattern of printing was vivid and the brightness was good. Sovereign item 1, a new process for the printing of heat transfer film hoses, is the printing of hoses based on the purchase of existing equipment based on a new printing process, which is characterized by the following steps: (1) adding heat Printing film, the rubber wheel in the equipment is heated by baking of the thermal tiles in the equipment; (2) Start the switch; (3) Press the cylinder in the equipment to press the heated rubber wheel to the transfer film In the above, until the transfer is completed, that is, the heat transfer film is pressurized at a high temperature, the glue on the heat transfer film adheres to the hose, that is, it is completely and firmly adhered to the hose; (4) the film motor starts Roll film; (5) Finish the thermal transfer action and press down the cylinder back to the original position; (6) After the roll film sensor senses the length of the transfer film, stop the film; (7) Remove the soft after transfer (8) Apply the hose to the membrane; (9) Go back to step 1.