Ribbon ink is not as full as possible

When a high-quality ribbon is touched by hand, no obvious ink marks will be left on the finger. However, if the poor-quality ink is touched by hand, it feels oily. It looks like the ink is sufficient, but the printed proofs are touched by hand. Blur will occur as if using inferior jet ink. Due to the coarse particles, the ink is difficult to infiltrate into the tape base of the ink ribbon. Therefore, the ink tends to remain on the surface of the ink ribbon and is left on the hand by hand. This is definitely not a matter of "abundant use of materials." Instead, it is crude. Also because of this ink's false "adequate", coarse ink particles will not only cause low adhesion and affect the printing effect caused by re-color phenomenon, and it can also be along the print pin guide hole between the print head stitches, over time. As it passes, it solidifies under the action of dust and jams the print head, causing serious malfunctions in which the printer cannot print normally.

Therefore, when the ribbons are purchased, the ink on the surface cannot be seen to be “sufficient” to be bought immediately. A good ink ribbon has better ink flowability and wettability. Generally, it is not sticky on the hand without force wipe. On the obvious traces, it is not easy to happen with the different layers of the ribbon with the base adhesion phenomenon, the ribbon with these characteristics is worth buying genuine.